The Microclean SC1000 cleans SMT stencils and misprinted PCBs, removing solder paste and adhesives to the highest cleaning standards.
Operation is fully automatic, with PLC-based controls. The operator simply places the stencil inside the chamber, selects from up to eight programs, closes the interlocking lid and presses the ‘Start Cycle’ button.
Cleaning is by motorised rotating spray jets (the system does not use ultrasonics) pump pressurised at up to 60 litres/minute and 4 bar. This is followed by air purging, DI rinsing, a further air purge, and warm air drying.
The SC1000 stencil cleaner uses safe and economic aqueous chemistry with closed loop operation to minimise waste effluent.

SMT行业的模板清洗

SMT（表面装配技术）的模板用SC1000模板清洗机能够达到最高的清洗标准。该系统可按照全球领先的印刷电路板制造商和分包商的要求，消除焊膏和胶粘剂，满足其要求的洁净规格。
SC1000模板清洗机，具有显著的成本效益
SMT报废率显著减少
SC1000模板清洗机使用安全，经济。
全闭环运行系统意味着没有废水在运行中流走，造成浪费
全自动运行，能使操作者在使用机器的时候，承担其他任务
清洗液从旋转的喷嘴中喷出，独特的设计可以更好的保护模板。
相比较于手工清洗，可以避免过度磨损和损坏，从而延长模板的寿命。